Note: Some batteries will be located in the security panel itself, adjacent to the keypad, or directly behind it. If you can’t locate the transformer, or it’s screwed in, the quickest method is to just cut the power from the circuit breaker, remove the battery, and then locate or remove the transformer. ![]() Disconnect it and, so long as you’ve unplugged the transformer, the alarm should stop. ![]() The battery is usually attached by two leads, similar to how 9-volt batteries attach to a plastic or rubber flap with both a positive and negative terminal. ![]() Unless the previous owner or renter provided you with one, you’ll have to figure out a way into it to access the battery. If you live in a home with a previously installed system, the panel box may not be accessible through “traditional” methods, such as a key. After you’ve unplugged the transformer- a large, square plug that’s usually screwed into the power outlet-you’ll have to gain access to the panel box. The panel box is where you will find the battery. Many of the older versions have a panel box that’s separate from the keypad. ![]() There are several different ADT security systems, though all essentially follow the same routine. How to Turn Off Your ADT Alarm without a Code
0 Comments
Leave a Reply. |